WebJan 11, 2016 · When the network cable is plugged in and, say eth0 is up and running, everything is fine (my multicast setup works nicely). If only lo is available (and up and … WebMar 22, 2016 · 使用ip_add_membership选项每次只能加入一个网络接口的ip地址到多播组,但并不是一个多播组仅允许一个主机ip地址加入,可以多次调用ip_add_membership …
IP_ADD_MEMBERSHIP results in "No device found" despite …
WebIPV6_ADD_MEMBERSHIP, IPV6_DROP_MEMBERSHIPControl membership in multicast groups. pointer to a struct ipv6_mreq. IPV6_MTUgetsockopt(): Retrieve the current known path MTU of the current socket. Valid only when the socket has been Returns an integer. setsockopt(): Set the MTU to be used for the socket. WebSC27-3660-00. Use the IP_ADD_SOURCE_MEMBERSHIP option to join an IPv4 multicast group on an IPv4 interface and specify the IPv4 source-filter address. Set these values … poole camhs number
c++ - setsockopt fails and returns -1 - Stack Overflow
WebApr 1, 2024 · The ip_mreq structure is used with IPv4 addresses. The ip_mreq structure is used with the IP_ADD_MEMBERSHIP and IP_DROP_MEMBERSHIP socket options. … WebJul 6, 2024 · Attempting to use IPV6_ADD_MEMBERSHIP in this way results in an EINVAL error on Linux. Instead try using the appropriate setsockopt () call to add it to an IPv4 multicast group instead (i.e. using IP_ADD_MEMBERSHIP) using a normal struct in_addr containing a native IPv4 address instead of a struct in6_addr containing an IPv4-mapped … WebUse the IP_ADD_SOURCE_MEMBERSHIP option to join an IPv4 multicast group on an IPv4 interface and specify the IPv4 source-filter address. Set these values by using the SETSOCKOPT API and specifying the address of the IP_MREQ_SOURCE structure that contains these addresses. shard court of the dead